Skip to content
Soteriaa
Welding inspection and testing

Destructive test report (bend, nick-break, tensile, macro) template

Laboratory results for guided bend, nick-break, tensile, macroetch, hardness and fillet fracture specimens from a WPQ, PQR or production coupon.

What you’ll need

  • Test piece reference and what it qualifies
  • Specimen results per test type
  • Laboratory and report number
  • Tested and reviewed by

Editable Word, PDF and Markdown.

Create destructive test report (bend, nick-break, tensile, macro) ↗

Create this document free. Guided forms, manual editing and downloads need no purchase. AI drafting uses your account allowance.

Sign in only when you want AI drafting or private saving.

Get the five-document pack →

A draft record of the information you supply. Review before use; it does not certify qualifications, perform checks or establish compliance.

Template preview · your information replaces the placeholders

DOCUMENT PREVIEW

Destructive test report (bend, nick-break, tensile, macro)

Test piece

[Add your information]

Bend and nick-break

[Add your information]

Tensile

[Add your information]

Macro, hardness and fillet

[Add your information]

Certification

[Add your information]

Review

[Add your information]

Keep every specimen traceable

Identify the test piece before recording a result. Use the same coupon or specimen reference on the request, laboratory report and the WPQ, PQR or production record it supports. Record the material, thickness, welding process and report number from the source documents rather than filling gaps from memory.

What to enter for each test

  • For a bend specimen, give its identifier, bend type and the observed result.
  • For tensile testing, enter the measured dimensions, load, reported strength and failure location.
  • Record nick-break, macroetch, hardness or fillet-fracture findings only when those tests were actually performed.
  • Finish with the laboratory, report number, test date, tester and reviewer shown by the evidence.

A useful entry might say “specimen B-01 | face bend | see laboratory report LAB-014”. These references are fictional examples of how to connect a row to its source, not a test result or an acceptance decision. Keep the signed laboratory report with the final record so someone can check the measurements and observations.

The form records results you supply. It does not conduct a test, calculate acceptance, or establish that a welder or procedure is qualified. Apply the acceptance criteria from the relevant contract and standard during review.